ELAC DS-A101-G Control4 Driver

This IP control driver is compatible with the following models:

• DS-AMP101-G

Driver Installation

1. On the ELAC website interface, or by using the DHCP reservation function of the router, set a static IP for the amplifier on the same network as the Control4 controller
2. Update to the latest firmware for the ELAC amplifier. This process may take time to complete.
3. Add the driver to the My Documents/Control4/Drivers folder
4. Start Control4 Composer and connect to Director
5. Add the driver to the required room by using the Search tab to find the correct model
6. Under Connections - Network, add the IP address of the amplifier
7. Connect the correct bindings for input source and room source/volume as required

Experience Button

A high resolution Bluetooth logo is included with the driver. This allows the Bluetooth input to be used as a source on the Control4 system.

1. Under System Design click on the room name then the Navigator tab.
2. Go to the Listen section and hide or show the Bluetooth logo.

Hint: Hide the amp driver to avoid end-user confusion.

Driver Support

• Contact ELAC Support for all support related issues.

This driver was developed by Blackwire.