The ELAC IS-AMP1650-BK is an 16-channel DSP matrix amplifier. The amplifier features speaker presets for ELAC plus the ability to modify the full parametric EQ per zone. Eight assignable analog outputs are included allowing you to do a combination of LFE or Stereo outs to a secondary amplifier lock to each source.
Featuring the latest discrete Class D technology the amplifier outputs 50 Watts per channel.
I/O Setup
Audio Routing Setup
EQ Setup
Specs
- Speaker Channels: 16
- Power Output Stereo:
- 50W @ 4 ohm
- 50W @ 8 Ohm
- Power Output Bridged:
- 100W @ 8 Ohm
- Analog Outputs:
- 4 Pair RCA Stereo or 8 Single RCA Mono (Mixable – Assignable)
- Inputs: 8 Pair Stereo RCA
- Size: 17.5″W x 6″H x 16.25″D
- Power:110/230V Switchable
What's in the box
- Amplifier x1
- Rack Ears x1
- Power Cord x1
Control4 Driver
Firmware
IMPORTANT: It is recommended to install the firmware below on the amplifier before setting up the driver. The firmware update requires about 10 minutes to fully install and update. Do not rush this!
Download the file below and unzip it.
Log into the Elac amp web menu and click on Update then select the .hex file you unzipped. The amp will download and install the firmware. It is best to simply walk away for 5 minutes. If after 5 minutes the firmware version has not updated to 0.68.69.129.16 refresh the page to check again. If it has ran into any errors unplug the amp for 5 minutes then plug it back in and wait 5 minutes and refresh and confirm again.
68-69-129-16-IS-AMP1650-BK