3G
508POE

4K video and HDCP 2.2
All audio formats
Instant-seamless switching
Built-in video scaler
Video Wall
2-way RS232 control
IR control (Requires additional hardware)
Image Pull
Image Push
Power over Ethernet
CEC Control

3G
509POE

4K video and HDCP 2.2
All audio formats
Instant-seamless switching
Built-in video scaler
Video Wall
2-way RS232 control
IR control (Requires additional hardware)
Image Pull
Image Push
Power over Ethernet
CEC Control

Ethernet Loop to power another receiver or networking device.

3G
518AVP

4K video and HDCP 2.2
All audio formats
Instant-seamless switching
Built-in video scaler
Video Wall
2-way RS232 control
IR control (Requires additional hardware)
Image Pull
Image Push
Power over Ethernet
CEC control
Stereo audio extraction with amp & delay
USB 2.0

The 509POE features an ethernet loop out. This can be used for a few things. 

  1. Power an additional J+P receiver: Keep in mind the receiver that is daisy chained will be seeing the same video source if you are using VLAN Switching. If you are using IGMP switching then you can set different sources on each display in the chain. There can be bandwidth limitations, so its best to contact us to do a system design review. 
  2. Networking Output: The receivers networking port will hand out a DHCP address from the J+P Networking scheme. Example: 192.168.200.XXX would be handed to the device plugged into the ethernet out. This can be used to add networking to TVs and video streamers etc. This is NOT to be used for something like a Wifi Access Point. The static route setting in your router will allow the devices on the J+P networking to communicate with your automation system. Keep in mind things like Control4 SDDP will not work so you will need to ID the devices via their IP address. 
in Just Add Power – HD Over IP

0

0